Hacker News

points by rootusrootus 2 days ago | 0 comments

> I've driven screws with a hammer

That takes a lot of commitment, you really have to want that screw in pretty badly! And when you're done it ends up just being a worse nail.

[–] jacquesm 2 days ago

There are nails that have threads on them that are made especially for this purpose.

[–] rootusrootus 2 days ago

That's fair, ring shanks are a thing, but I was thinking more along the lines of a wood screw with deep threads. That just sounds like looking for pain. I'd expect it to chew things up pretty badly, too, though I have so far lacked the commitment to try pounding a screw with a hammer ;).

[–] jacquesm 2 days ago

https://buildingsandmoreng.com/products/3-twisted-iron-nails...

[–] AngryData 2 days ago

Ring shanks do exist, but they are also made with a softer iron so it can be struck with a hammer and bend instead of fracture or snap off.

[–] IAmBroom 2 days ago

No, there aren't. Ring shanks have ridges, not threads.

[–] tfvlrue 2 days ago

I think they were talking about spiral shank nails, not ring shank. It has a twisted grove along the shank of the nail, sort of like an extremely course thread.

I've seen these used to assemble wooden palettes (they are VERY hard to remove). A search on Home Depot reveals they may be used for certain types of siding as well.

[–] jacquesm 2 days ago

'coarse'

I built a house with them. You really want to check twice if you're putting them in where you want them because getting them out is - as you noted - annoyingly difficult. But they're very nice for large surfaces that are going be battered by the wind, they're much longer than your typical screw and working with them is very fast.

[–] jacquesm 2 days ago

See other comment.